ZMODO NVR - NVR Hardware and Controls; Rear Panel Ports

3
Rear Panel Instruction
Table 0-2Rear Panel Description
NO.
Interface
Description
1
VGA Output
1: DIN-15
Alarm Input
4 Channel Input
Alarm Output
1 Channel Output
2
Network Interface
1 : RJ45 10/100M
USB Interface
2: USB 2.0
3
RS485
1: Send & Receive Data, half-duplex interface (+ -)
4
power
DC 12V
Remote Control
Table 0- 3 Remote Control Description
NO.
Name
Description
1
Power
Turn on/off the device
2
Rec
Start/Stop recording
3
NO. (1-9)
• Input numbers in the editable box
• One key channel selection in preview mode
• One key channel selection in playback mode, and enlarge the
single-channel screen
4
NO.10+
•Apply for group use to choose channels above 10 in preview
mode
•Apply for group use to choose channels above 10 in playback
mode, and enlarge the single-channel screen
5
NO.0
Input 0 in the editable box
6
Backspace, delete input in the editable box
7
Direction: Left
8
Direction: Right
9
Direction: Up
10
Direction: Down
11
OK
1) Press to confirm in menu mode
2) Check or un-check configuration boxes in menus
3) Select or deselect motion detection areas in the motion
detection settings
12
Switch from single screen and multi-screen in preview mode