5) Power on your Pivot and tap the check mark once the Pivot’s Status Ring is
blinking green. The blinking green Status Ring means that it is ready for
SmartLink setup.
6) Tap the check mark to proceed. If you’re setting up multiple Pivots at once,
tap the [ + ] to add additional units.
7) Enter the password for your 2.4GHz WPA/WPA2 password-protected WiFi
network. This is the network that your Pivot will connect to. If you are having
trouble connecting to the network, please:
• Make sure that you have entered the WiFi password correctly (case-
sensitive).
• Check if your router is dual-band. If so, make sure that the 2.4GHz and
the 5GHz signals broadcast on different SSIDs.
• Make sure that your Pivot is close enough to the router, or an access
point.
To Next Page
Loading...
