9
Backwashing the Pool Filter
Always disconnect the cleaner from the skimmer box before cleaning or backwashing the pool filter.
After cleaning or backwashing, let the filtration system run for at least five (5) minutes to flush
out the suction lines before re-connecting the cleaner.
Adding Chemicals
Remove the cleaner from the pool for at least four (4) hours when adding chemicals.
Replacing Brushes Regularly
To maintain optimal cleaning, it is recommended to replace the scrubbing brushes each
season or when significant wear is visible. To remove brushes, squeeze the yellow plastic clip
between two fingers and pull out. Type of pool surface may also increase rate of wear to brushes.
NEW
brush
surface
WORN
brush
surface
Everyday Storing
Never store the cleaner in direct sunlight. Always remove the hose from the cleaner head. Do not coil the
hose, even for short time. Hose may develop a memory which can affect cleaner performance. Store the
cleaner on its side or back to avoid damage to the turbine and brushes.
Care and Maintenance
®
Rainbow Pool Products
PO Box 2388, Mansfield Qld 4122
Telephone STD 61-7-3849 5385
Facsimile STD 61-7-3849 5384
Email: info@rainbowpoolproducts.com.au
Web: www.rainbowpoolproducts.com.au