9
2.3 I Electricity supply connecon
In order to avoid any risk of electrocuon, re or serious injury, please follow the instrucons
below:
• Use of an electrical extension is prohibited when connecng the control box.
• Make sure that the socket can be easily accessed at all mes and is protected from rain or
splashes.
• The control box is splash-proof, but must not be immersed in the water or any other liquid.
It must not be installed in a oodable area; keep it at least 3.5 metres away from the edge of
the pool and avoid exposing it to direct sunlight.
• Place the control box near the socket.
• Unscrew the protecve cap (see gure ).
• Connect the oang cable to the control box and lock it into place by turning it clockwise (to avoid damaging the
oang cable) (see image
).
• Make sure that the connector is fully pushed in so that no water can get in (see image
).
• Connect the power cord (see gure
). Only connect the control box to a power outlet protected by a 30 mA
maximum residual current device (if in doubt contact a qualied technician).
To Next Page
Loading...
Need help?
General
