15
2.8 I Removing the cleaner from the water
• To prevent damaging the equipment, use only the handle to remove the appliance from the
pool.
2.8.1 "LIFT SYSTEM" automated mode
The "Li System" funcon was designed to facilitate removing the cleaner from the water. It may be acvated at any
me, during or at the end of a cleaning cycle.
• If necessary, press and hold the buon
me, during or at the end of a cleaning cycle.
to direct the cleaner towards the required wall, the cleaner pivots.
When facing the right wall, release the buon. The cleaner moves towards the wall (see image ).
• Or just briey press the buon
When facing the right wall, release the buon. The cleaner moves towards the wall (see image
to move it towards the opposite wall (see image ).
• The cleaner climbs the wall and stays at the waterline (see image ).
• Use the handle to take it out of the water. The cleaner expels water through a rear jet to make it lighter (see
image ).
01'30''
2.8.2 Manually
• Switch o the appliance by pressing .
• Bring the cleaner to the edge of the pool by gently pulling on the oang cable.
• When possible, pick up the cleaner by the handle and li it gently out of the pool so that the water it contains drains
into the pool (see image and ).
To Next Page
Loading...
Need help?
General
