13
3.6 I Ending the cleaning cycle
• To prevent damage to the equipment:
- Do not pull on the cable to remove the appliance from the pool. Use the handle.
- Do not leave the appliance to dry out in sunlight aer use.
- Store all the elements away from sunlight, humidity and bad weather.
- Screw the protecve cap back on if you unplug the control box power cord.
• Switch o the appliance by pressing .
• When the cleaner is within arm's reach, pick it up by the handle and li it gently out of the pool so that the water it
contains drains into the pool (see gure ).
• Place the cleaner vercally in the locaon provided on the caddy (depending on the model) for it to dry out quickly
(see gure
).
• Then store it with the control box away from sunlight and any splashes. A protecve cover is available as an oponal
extra (see gure
).
3.6.1 "Remove from pool" mode (depending on the model)
This funcon enables the cleaner to return to an exact point at the edge of the pool. When it climbs the wall, the cleaner
sprays a jet of water behind it to make it lighter as it exits the pool.
• Direct the cleaner towards the required pool wall, then make it climb to the water line: hold down to rotate it.
The cleaner moves towards the wall when you release the buon.
Tip to prevent the oang cable from becoming tangled
The cleaner's behaviour is strongly impacted by the tangling of the cable. A cable that is correctly untangled
will guarantee beer coverage of the pool.
• Untangle the cable and lay it out in the sun so that it returns to its original shape.
• Then wind it up carefully and place it on the caddy handle (depending on the model) or on a xed support.
To Next Page
Loading...
Need help?
General
