22
The remote control LED is ashing
slowly or the LED is steadily lit.
Remote control range problem:
• Posion the control box on the caddy at least 3.5 metres from the pool.
• Orient the control box towards the pool in order to improve the range of the
remote control. Ensure there are no large obstacles between the control box
and the pool.
The remote control LED is steadily
lit.
• Synchronisaon problem: repeat the synchronisaon steps (see §”3.8.4
Synchronising the remote control with the control box”).
5.2 I User alerts
User alerts (depending on the model)
Soluons
Flashing LED:
Error code:
Er: 10
• Check that the cleaner is correctly connected to the
control box. If necessary, unplug it and reconnect it
following the appropriate procedure.
Er: 02
Er: 03
Er: 05
Er: 06
• Check that there is nothing prevenng the brushes
and wheels from turning. To do so, turn the wheels
(1/4 turn) to release any debris that may be jammed.
Er: 07
Er: 08
• Cleaner operang outside the pool. Make sure you
start the cleaner when it is in the water (see § “3.3
Immersing the cleaner”).
Er: 01
Er: 04
• Check that there are no stones or hair in the propeller.
• Clean or change the lter if necessary.
5.2.1 Error codes
• Pressing a key deletes the error code and turns o the control box.
• The screen switches to standby aer 10 minutes. To turn the screen back on, press any key.
• When an error is detected, the control box temporarily suspends the programme (the LED is turned o).
• Press and hold the key to re-conrm the current programming.
EN
To Next Page
Loading...
Need help?
General
