16
3.8 I The remote control (depending on the model)
• Respect the baery polarity.
• Do not recharge the baery, dismantle it or throw it onto a re.
• Do not expose it to high temperatures or direct sunlight.
3.8.1 Switching the remote control on and o
• To switch on: press .
• To switch o: press and hold .
Tip: improve the remote control recepon.
The frequency of the ashing of the led located on the remote control indicates the recepon quality. If the
LED ashes quickly, recepon quality is OK.
For the best communicaon between the control box and the remote control:
- Posion the control box on the caddy.
- Turn the control box towards the pool
- Removal all large obstacles between the control box and the pool.
3.8.2 Direcng the cleaner
• The remote control is equipped with movement sensors to direct the cleaner:
: Forwards
: Backwards
: Le turn
: Right turn
: Stop
3.8 Taking the cleaner out of the water (depending on the model)
• Press . The cleaner moves toward the wall and climbs up to the waterline.
3.8.4 Synchronising the remote control with the control box
By default, the remote control is already synchronised with the control box. If replacing the remote control/control box
or if a synchronisaon problem occurs, follow the steps below:
• Place the remote control a maximum of 50 cm away from the control box.
• Connect the control box, check that the display shows the operang me, and that no cleaning cycle is running.
• Switch on the remote control by pressing .
• Before the remote control switches to standby (around 45 seconds) press the and buons simultaneously
for 6 seconds.
• Check that synchronisaon was successful by observing the display and the remote LED:
Display on the
control box
Remote LED
Result
Good
0:45
2 seconds
Flashing
• Synchronisaon successful.
FAIL
On steady
• Check that the distance between the control box and the remote
control is 50 cm maximum.
• Check the remote control baeries. Replace them if necessary.
If the problem connues contact your retailer.
EN