What to do if my Zoeller 1043-006 Water Pump will not run?
If your Zoeller Water Pump won't run, first, ensure it's properly plugged into a 115-volt outlet. Also, the motor may have overheated; it has an automatic thermal protector. Wait 15 minutes to allow the motor to cool down.
What to do if Zoeller 1043-006 runs, but no water is discharged?
If your Zoeller Water Pump runs but doesn't discharge water, check for a kinked hose. Also, the discharge height might be too great; try reducing it. Finally, inspect the inlet for clogs and clean it if necessary.
How to increase the flow rate of my Zoeller 1043-006 Water Pump?
If the flow rate of your Zoeller Water Pump is low, start by straightening the hose to remove any kinks. Also, check the impeller for any obstructions and clear them. If the outlet hose is excessively long, try reducing its length.
Why does my Zoeller 1043-006 Water Pump motor run too hot?
If the motor of your Zoeller Water Pump runs too hot, ensure it is connected to a 115-volt outlet. A restricted discharge hose could also be the cause, so try increasing the hose diameter to 3/4-in. Additionally, check for and clean any plugs or kinks in the discharge hose. If none of these solutions work, the pump may be damaged and require replacement.
Lists the components included with the pump package, such as the pump and adapter.
Provides critical safety warnings and precautions for operating and handling the pump.
Details steps to ensure all parts are present and ready before assembly.
Guides on how to attach hoses and place the pump correctly.
Explains how the pump functions, including automatic shut-off and restart.
Provides instructions for routine inspection, cleaning, and upkeep of the pump.
Lists common problems, their possible causes, and corrective actions.
Outlines the product warranty terms, coverage, limitations, and registration.
General| Model | 1043-006 |
|---|---|
| Type | Submersible sump pump |
| Voltage | 115V |
| Cord Length | 10 ft |
| Housing Material | Cast iron |
| Impeller Material | Thermoplastic |
| Float Switch Included | Yes |
| Horsepower | 0.5 HP |
| Discharge Size | 1.5 in NPT |
| Phase | Single Phase |
| Switch Type | Vertical |
To Next Page
