9
Normal Operation
Setup and Prime
Connect bag, cartridge and IV sets
using standard IV bag spike with
Luer connectors. When infusing
blood products with the Blood
cartridge, always use an IV set
that is designed for blood products
and contains an appropriate screen.
Install cartridge: hold at an angle and engage
tab on the side of the cartridge;
swing over rocker until the 2
pegs on the cartridge snap
into the slots in the pump.
Turn pump on for battery
operation or connect option-
al power adapter.
Hold down
start/stop to
prime entire IV set. Tap
cartridge to remove air
bubbles. Stop pump.
Air elimination membranes in the
Crystalloid/Colloid Cartridge will not
function until the cartridge is primed and
To Next Page
Loading...
Need help?
General
