What does 'CO2 COMM ERROR' mean on ZOLL M Series Medical Equipment?
If the ZOLL Medical Equipment shows 'CO2 COMM ERROR', it means there's no communication from the EtCO module or sensor. Turn the M Series unit off, then on again to reset it. If the problem continues, the unit may require servicing.
What does 'CO2 UNIT ERROR' mean on ZOLL M Series?
If your ZOLL Medical Equipment displays 'CO2 UNIT ERROR', it indicates a defective EtCO module or sensor. Try turning the M Series unit off and then on again to reset it. If the problem continues, contact Technical Support.
What does 'INVALID CO2 DEVICE' mean on my ZOLL Medical Equipment?
If your ZOLL Medical Equipment displays 'INVALID CO2 DEVICE', it means the CAPNOSTAT 3 sensor or LoFlo Module isn't responding to the M Series unit. Try turning the unit off and then on again to reset. You can also try using another sensor or module. If the problem persists, contact Technical Support.
What to do if ZOLL Medical Equipment shows 'ZERO FAILED'?
If the ZOLL Medical Equipment displays 'ZERO FAILED', it means the zero operation wasn't successful. Ensure there are no occlusions and remove any source of CO, then try zeroing again. If the problem persists, contact Technical Support.
Why does ZOLL M Series say 'CO2 DEVICE NOT READY'?
If your ZOLL Medical Equipment displays 'CO2 DEVICE NOT READY', it's because the sensor or module is still warming up, or no sensor or module is attached to the unit. Wait for the sensor or module to warm up. If nothing is attached, connect the sensor or module to the unit.
General| Pacer Rate | 30 - 180 ppm |
|---|---|
| Display Type | LCD |
| Defibrillator Type | Manual and AED |
| Monitor Display | High-resolution LCD |
| ECG Monitoring | 3-lead |
| Pacing | Demand |
| Battery Type | Lithium-ion |
| Display | High-resolution LCD |
| Waveform | Biphasic Truncated Exponential (BTE) |
| Monitoring Parameters | ECG, SpO2, EtCO2, NIBP, temperature |
| Connectivity | Data port for data transfer |
| Pacer Type | Transcutaneous |
| Pacer Output | 0 - 140 mA |
| Printer | Integrated thermal |
| Energy Selection | 2, 3, 5, 7, 10, 15, 20, 30, 50, 70, 100, 120, 150, 200 Joules |
To Next Page
