Zonar V4 - Installation Checklist

V4™ Installation/User Guide
7
Installation Checklist
The following is an installation checklist broken down by task.
Task # Task Required? Page # Complete?
1 Inventory all V4 equipment Required 8
2 Layout all cables and accessories according to: Required -
3 -General guidelines Required 9
4 -V4 device and mounting plate instructions Required 11
5 -Power / Data cables instructions Required 14
6 -External GPS Antenna guidelines If used 23
7 -Discrete input system instructions If used 32
8
Disconnect vehicle battery ground cable
Suggested
9 Install V4 Power / Data cable. Do not connect 4 Pin
connector to V4 at this time. Do not connect OBDII
connector to vehicle at this time (If used) Required 14
10 Install Discrete Input cable If used 32
11 Install external GPS antenna If used 23
12 Install V4 mount plate & V4 Required 11
13 Interconnect all cables & wires to V4 (except 4 pin power) Required 14
14 Reconnect vehicle battery ground cable Suggested -
15 Connect 4 pin power cable to V4 Required 14
16 Start engine Required -
17 Connect OBDII connector to vehicle (if used) Required 14
18 Complete V4 System functional checkout & checklist Required 24
19 Shutdown engine Required -