Need help?Do you have a question about the Zonestar P802QS and is the answer not in the manual?
General| Nozzle Diameter | 0.4 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Heated Bed | Yes |
| Print Technology | Fused Deposition Modeling (FDM) |
| Supported Materials | PLA, ABS, TPU |
| Frame Material | Aluminum |
| Nozzle Temperature | Up to 260°C |
| Display | LCD |
Assembles the Y-axis belt pulley mechanism.
Assembles the left slider module.
Assembles the right slider module.
Mounts the X-axis stepper motor to the slider.
Attaches the left slider module and guide rods.
Attaches the right slider module and guide rods.
Safety warnings and important notes for electrical wiring.
Detailed wiring diagram for single extruder configurations.
Detailed wiring diagram for dual extruder configurations.
Wiring diagram for dual extruders with mixed color setup.
Explanation of control board jumpers and LED indicators.
Instructions and diagrams for connecting the power supply.
Procedure for setting the correct motor drive current.
To Next Page
