Need help?Do you have a question about the Zontes ZT350-GK 2022 and is the answer not in the manual?
General| Brand | Zontes |
|---|---|
| Model | ZT350-GK 2022 |
| Category | Motorcycle |
| Language | English |
Remove the dump switch/ECU.
Horn/Shut down switch/Ignition coil.
Remove fuel tank liner, cushions, and other plastic parts.
Disassembly and assembly of the steering column.
Procedures for oil release, oil cooler, and side support.
Remove engine and engine left rear cover.
Remove air temp sensor, electromagnetic valve, and carbon tank.
Remove air filter, throttle valve, and check sensors.
Remove throttle body, check sensors and stepping motor.
Remove air filter element and clean oil pipe.
Remove the rear mudguard.
Remove and adjust the rear shock absorber.
Remove the rear wheel and chain adjuster.
Remove the rear sprocket seat and buffer.
Remove disc brake, ABS ring, tire, and wheel.
Remove the rear fork and rear resistant block.
Disassemble and change the rear disc brake arrester.
Add brake fluid to the rear brake master pump.
Adjust gear shift rod height and lever position.
Remove right pedal support and muffler parts.
Remove rear brake main pump heat shield/component.
Remove brake pedal and muffler anti-scalding.
Remove R, front/rear pedals, and after-sales parts.
Remove L, foot pedal holder, gear shift rod, rectifier.
Remove gear shift rod.
Remove rear left pedal and parts.
Drain and refill engine oil.
Replace engine oil filter and associated seals.
Add coolant to the cooling system.
Remove right and left water tank trim covers.
Remove bottom plates of decorative covers.
Remove the middle trim panel of the water tank.
Remove auxiliary water tank and its support.
Drain cooling liquid from the system.
Assemble and disassemble the main water tank.
Disassemble and assemble main water tank parts.
Remove water tank brackets.
Remove oil cooler and associated pipes.
Remove oil cooler bracket.
Adjust throttle and clutch cable clearance.
Adjust light height and replace clutch cable.
Replace the throttle cable.
Adjust the steering system.
Remove and install right hand controls and parts.
Add brake fluid and adjust rocker.
Replace front brake pads.
Remove front wheel, brake disc, and ABS ring.
Remove front mud board and wheel speed sensor.
Remove front disc brake guard and mud board.
Remove speedometer and headlight assembly.
Remove headlight bracket and assembly.
Remove head cover and mask.
Remove turn signal components.
Remove junction box and USB cable.
Remove left mirror, switch, hand guard, rubber sleeve.
Remove directional lever components.
Remove shock absorber and upper plate.
Remove uplink plate and handle block.
Remove hydraulic control unit components.
Release brake fluid.
Remove disc brake components.
Remove RC-HU and related parts.
Remove fuel tank assembly and related parts.
Remove fuel tank middle cover.
Remove fuel tank outer cover.
Remove oil pump and related parts.
Remove left and right side covers.
Remove charging port base.
Remove upper parts of side covers.
Install right/left side covers.
Remove guard bar and head wiring box.
Remove left and right guard bars.
Remove electric device box cover.
Remove battery, relay, and flasher.
Remove rear armrest and taillight holder.
Remove PKE assembly and antenna.
Remove electrical device box.
Remove electric device box components.
Remove rear mud board and taillight assembly.
Remove rear license plate bracket and reflector.
Remove and install the seat cushion.
Remove muffler shroud and rear assembly.
Remove rear muffler decorative cover and assembly.
Remove muffler front assembly and oxygen sensor.
Remove lower shroud assembly and brackets.
Remove lower shroud parts.
To Next Page