Zoom F4 - Supplying power; Using AA Batteries

Functions added in Version 3.0
Setting signals sent to the output jacks (Routing)
14
Setting signals sent to the output jacks (Routing) (continued)
NOTE
• You cannot setthe the L/R, MAIN OUT 1/2, SUB OUT 1/2 or
U1-U4 tracks to prefader.
• You cannot select the the 1-6, L/R, MAIN OUT 1/2, SUB
OUT 1/2 or U1-U4 tracks at the same time. Selecting one
will deselect any other.
HINT
Press
E
to cycle through the options:
Prefader → Postfader → Off.
6. To make the headphone out-
put mono, use e to select
MONO MIX, and press E.
7. To monitor a mid-side stereo
signal, use e to select
MS, and press E.
NOTE
• Mid-side stereo monitoring is disabled for stereo-linked
tracks that have Stereo Link Mode set to MS Stereo Link.
• When mid-side stereo monitoring is enabled, the pre-
fader tracks will be routed automatically to the headphone
channels, with odd to the left and even to the right. In this
case, the routing cannot be changed manually.
HINT
Signals from a mid-side stereo mic can be converted to an
ordinary stereo signal for monitoring (MS stereo monitoring).
8. Press m.
Setting signals sent to the output jacks (Routing)