Zoom H4n Pro - Page 144

143
9LMLYLUJL4;9TVKLLɈLJ[[`WLZHUKWHYHTL[LYZ
4;9TVKLLɈLJ[[`WLZHUKWHYHTL[LYZ
Q,-?TVK\SLZ
O*VTWYLZZVYSPTP[LYLɈLJ[Z
RackComp
Compressors reduce high-level signals and raise the
minimum level.
(1) THRSHOLD 0–50
Sets the base level from which the compressor
operates.
(2) RATIO 1–10
Sets the compression ratio.
(3) ATTACK 1–10
Sets how quickly compression starts.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
LIMITER
3PTP[LYZJVTWYLZZ^OLUPUW\[ZPNUHSZL_JLLK[OLÄ_LK
level.
(1) THRSHOLD 0–50
This sets the base level from which the limiter
operates.
(2) RATIO 1–10
Sets the compression ratio.
(3) RELEASE 1–10
Sets how quickly the limiter stops functioning
after the signal goes below the base level.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
O4VK\SH[PVULɈLJ[Z
AUTO WAH
;OPZ^HOLќLJ[YLZWVUKZ[VJOHUNLZPUPUW\[ZPNUHS
strength.
(1) POSITION
Before,
After
Sets the insertion point of the EFX module.
Select before or after the PREAMP.
(2) SENSE
ò¶ò
1–10
:L[Z[OLLќLJ[ZLUZP[P]P[`
(3) RESONANC 0–10
Sets the amount of resonance.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
PHASER ;OPZLќLJ[]HYPLZ[OLZV\UK^P[OWOHZPUN
(1) POSITION
Before,
After
Sets the insertion point of the EFX module.
Select before or after the PREAMP.
(2) RATE
0–50, ʖ
(See P.146)
Adjusts the speed of modulation.
(3) COLOR
4STAGE,
8STAGE,
INVERT4,
INVERT8
:LSLJ[[OLLќLJ[ZV\UK[`WL
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
TREMOLO ;OPZLќLJ[YHPZLZHUKSV^LYZ[OL]VS\TLJ`JSPJHSS`
(1) DEPTH 0–50
Adjusts the modulation depth.
(2) RATE
0–50, ʖ
(See P.146)
Adjusts the speed of modulation.
(3) WAVE
UP 0–9
DOWN 0–9
TRI 0–9
Select the modulation waveform from UP (rising
sawtooth), DOWN (falling sawtooth) and TRI
(triangle) types.
The higher the number, the more the wave peaks
HYLJSPWWLKLTWOHZPaPUN[OLLќLJ[
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.