Zoom H4n Pro - Audio Interface Operation Notes

:LSLJ[PVUVMPUW\[ZV\YJL
When you select an input the corresponding
EXWWRQ OLJKWV FRQÀUPLQJ WKH VHOHFWLRQ 7R
turn off the input, press the corresponding
button so the light turns off.
To monitor input signals, you must turn
MONITOR on.
Note: If no input is selected and no input buttons are
lit, no signal is being sent to the computer.
032
:L[\W<ZPUNHZH<:)H\KPVPU[LYMHJL
(KQ\Z[PUW\[HUKV\[W\[SL]LSZ
6WLU4,5<HUKTHRLZL[[PUNZ
;OLZLI\[[VUZHYL\ZHISL
K\YPUNZL[[PUN
)\[[VUVWLYH[PVUPU(<+060-TLU\
7YLZZ
:LSLJ[
HUKWYLZZ
(<+060-4,5<
EFFECT <ZLLɈLJ[ZVUS`R/a
TUNER Use tuner
MONITOR Enable monitoring
PHANTOM Enable phantom power
PLUG-IN Enable plug-in power
DISCONNECT End connection

• You cannot change the sampling
YH[L^OPSL [OLJVTW\[LYPKLU[PÄLZ
the H4n Pro as an audio interface.
• When connecting as an interface,
make sure the sampling rate (step
6) matches the recording software
HUKWSH`IHJRÄSL
• You cannot changed this setting
during recording and playback.

Audio interface use
• You can record and playback
signals directly to and from your
DAW software using the H4n Pro.
• In this mode, you can use the
/U7YVZI\PS[PULќLJ[ZVUPUW\[
signals if the sampling rate is set
to 44.1kHz.
• 5V ZWLJPÄJ KYP]LY PZ ULLKLK [V
use the H4n Pro as a USB audio
interface.
• When using a DAW or other soft
-
ware, refer to its manual.