Setting the Precount for Real-Time Recording
The MRT-3 can perform a countdown before the start of real-time recording. The number of
precount measures can be changed, and precount can also be turned off. This setting affects all
patterns.
1.
In pattern mode, press the [FUNCTION] key and then pad 2 (PRE COUNT).
The current precount setting is shown on the display (default setting: 1).
2.
Use the [VALUE +/-] keys to select one of the following settings.
0: No precount
1: Precount of 1 measure
2: Precount of 2 measures
PAd: Recording starts when any pad is hit.
When "PAd" is selected, holding down the [REC] key while pressing the [PLAY] key in pattern mode
brings up the indication "rEAdy" on the display, and the unit goes into recording standby mode.
3.
When the setting is complete, press the [FUNCTION] key again.
The unit returns to the previous mode.
To Next Page
Loading...
