Zte Altair 2 - Sending Data; Receiving Data

29BLUETOOTH
Receiving data
1. Enable Bluetooth function and pair the phone with the device from which
you wish to receive the le.
2. When the paired device tries to send a le to your phone, a popup
dialogue will appear in your screen. Press the Left select key for Yes to
authorize the connection.
3. You will see another popup asking you to accept or reject the specic
le that the other device is sending. Press the Left select key for Yes to
accept the incoming le, or press the Right select key for No to reject the
incoming le.
28 BLUETOOTH
3. Wait 60 seconds for the phone to nish searching, or press the Right select
key for Stop if the target device appears in the list before 60 seconds
have elapsed.
4. Highlight a device from the list and press the Center select key for Pair.
5. Press the Center select key to initiate device pairing. You may be asked to
conrm a passkey.
When you pair your phone with another device, you will be given the option
to set incoming security. There are two options for incoming security: Always
Ask and Always Connect.
Always Ask: Require the other Bluetooth device that is connecting to your
phone to request connections in the future.
Always Connect: Authorize the other Bluetooth device to connect to the
phone without requesting in the future.
Note: Some devices don’t support automatic Bluetooth connections. You will
always need to connect manually with these devices.
Sending data
Before sending data, please conrm that:
• Bluetooth function is enabled.
• The device is visible and paired with the other device.
1. Open the le you wish to send. Press the Left select key for Options > Send
> Via Bluetooth.
2. Select the destination device from the list, and press the Center select key
to send the le.