5
Prepare the following accessories(not included):
Crosshead screwdriver
Flat head screwdriver
Hammer drill
Marker pens
Installation Precautions
Do not install the device in the following directions:
Do not install the device with
the interface side facing
upwards.
Do not install the device
horizontally.
Do not install the device
tilted.
WARNING!
The device must be installed downwards and vertically. It is not recommended to install the device in other
directions(including but not limited to the above scenarios). ZTE is not liable for any problem caused by
the installation in other incorrect directions.
Do not install the device at a high position (lightning area).
The device must be placed in a well-ventilated environment for use. If possible, install the device
in a place with less direct sunlight, for example, in the shade. The device must not be installed at
the outlet of the exhaust pipe, or installed in a place where water passes through, for example, a
rain shed.
The device shall be installed in the position of the site survey design drawings and within the
protection range of 45° of the lightning rod. In high mountains and areas with heavy lightning (the
number of thunderstorm days per year exceeds 180), ensure that the device is within the
protection range of 30°of the lightning rod.
When the device is mounted on the wall, it should better be more than 1 m away from the
grounding cable of the lightning rod and more than 20 cm away from the lightning protection
To Next Page
Loading...
