6
zone.
When installing the device against a pole, do not install a lightning rod on the pole. It is
recommended that an independent lightning rod be installed near the pole. If a lightning rod is
installed on the pole, it is recommended that the lightning rod be led out and grounded directly.
The mounting pole must be firm, cannot be shaken and must meet the wind-resistant
requirements (not less than level-10 wind speed).
The mounting pole should be vertical, and the vertical error should be less than ±2°.
Installation Modes
You can install the device in either of the following ways:
Install the device on a wall.
Install the device against a pole.
Requirements of Installation Space
To Next Page
Loading...
