15
WPS Function
Your device supports WPS function. You can use this func-
tion to connect the client to your device.
1. Power on your device, and enable the Wi-Fi function
on your device.
2. Enable the WPS function. Please check the WPS Set-
ting on the 4G CPE page.
3. Press the WPS button on your device to start Wi-Fi
Protected Setup authentication process.
4. Enable the WPS function on your client to respond to
this authentication process.
5. Follow the system prompts on your client to nish the
connection.
Wireless Connection
If you want to use Wi-Fi to connect your router, please refer
to the following steps.
1. Make sure that the WLAN works normal. Please check
the Wi-Fi Setting on the 4G CPE page or check the
WIFI indicator.
To Next Page
Loading...
