12
Establish a connection between your device
and the client
Via USB Cable
1. Connect your device and the client with the USB cable.
2. Power on your device.
3. Install software.
Notes:
If the operating system does not launch installation automatically, you
can run the installation program in path of My Computer >Mobile
Hotspot.
After the installation, the connection between your device and the cli-
ent will be established successfully a moment later.
Via Wi-Fi
1. Power on your device directly. It will take 1~2 minutes to initial-
ize, and then Wi-Fi OLED icon will be indicated on the LED
screen of your device.
2. Use your normal Wi-Fi application on the client to search the
available wireless network.
Notes: You need to check your Wireless Network Connection.
Set the client to obtain an IP address automatically in the Internet
protocol (TCP/IP) properties, and the client will get an IP address
like”192.168.1.101”.
To Next Page
Loading...
Need help?
General
