ZXDSL 831AⅡ User’s Manual
9
Figure 3.2-2 ZXDSL 831A Connection Schematic Diagram (Phone sets are Installed Before the Splitter)Ⅱ
Note:
In the circumstance where the first connection example is not applicable and
you choose to use the second example, you must install a MicroFilter on the
telephone cable (as illustrated in Figure 3.3-2, do not use a splitter to replace
the MicroFilter).
Installing a telephone directly before the splitter will lead to a failure of
connection between the ZXDSL 831A and Ⅱ the device at central office side,
or a failure of access into the Internet, or a slow connection speed. If you really
need to add a telephone set before the splitter, you have to add a MicroFilter
before the telephone set. Do not connect several telephones before the splitter.
Moreover, do not connect several telephones with MicroFilters.
The filter is not a standard-configuration device and you should separately
purchase it from the operator.
Connection procedures
1 Power off the equipment before all the other devices are connected.
2 Connect the network cables: Insert the RJ-45 Ethernet cable connector
into the Ethernet interface of the ZXDSL 831A , and connect its other Ⅱ
To Next Page
Loading...
