ZXDSL 831AⅡ User’s Manual
10
terminal to the Ethernet adapter of the customer computers or ports of other
network devices.
3 Connect the plug of the USB cable into the USB port of the ZXDSL
831AⅡ, connect the other end of the USB cable to the USB port of the PC.
4 Connect the splitter
The splitter has three interfaces, which are described as follows:
z LINE: Connect the user telephone cable (RJ11 interface).
z MODEM (or ADSL): Connect the DSL interface of the ZXDSL 831A . Ⅱ
z PHONE (or TEL): Connect the phone sets.
The installation process is as follows: Connect the DSL interface of the
ZXDSL 831A Ⅱ to the MODEM interface of the splitter using the RJ-11
telephone cable, connect the phone set lines to the PHONE interface of the
splitter, and then connect the user telephone cable port to the LINE interface
of the splitter.
5 Connect the power
Connect one terminal of the power adapter to the PWR interface of the
ZXDSL 831A , and the other terminal to the socket on the wall, and then Ⅱ
switch on the power of the ZXDSL 831A equipment. Ⅱ
Checking all connection cables
Check all connection cables following the below procedure.
1 Check the ADSL cable connection
If the DSL LED is on upon power-on of the ZXDSL 831A , Ⅱ it indicates
that the ADSL line is correctly connected (Generally it takes one to two
minutes to perform the ADSL connection).
2 Check the computer connection
If both the LINK LED on the computer adapter and the Ethernet LED of the
ZXDSL 831A turn green, Ⅱ it indicates that the computer and the ZXDSL
831A equipment are correctly connected. Ⅱ
3 Check the telephone cable connection
To Next Page
Loading...
