Zte ZXHN H2640 - Configure the SIP Protocol

6 Configure the VoIP
SJ-20200714160642-002 | 2020-07-27(R1.0)
6-5
Table 6-4 Parameter Descriptions of the Special Parameters
Parameter
Description
SIP DSCP Marking
DSCP value of SIP packets, the value range is 0–63.
RTP DSCP Marking
DSCP value of RTP packets, the value range is 0–63.
UPDATE
The UPDATE message is a mechanism for SIP extension. It updates
the media stream status when a call is not established.
9. Click Apply button to apply the changes.
6.4 Configure the SIP Protocol
This procedure describes how to configure the SIP Protocol.
1. On the main page of the ZXHN H2640, select VoIP > SIP Protocol. The SIP
Protocol page is displayed, see Figure 6-6.
Figure 6-6 SIP Protocol Page
Steps
Abstract