Zte ZXR10 2918E User Manual

Chapter4ServiceConguration
CommandFunction
zte(cfg)#lldp{port<portlist>|trunk<trunklist>}{txenable|txdisable}
EnablesordisablestheLLDPsending
functiononaspecicport.
zte(cfg)#lldp{port<portlist>|trunk<trunklist>}{rxenable|rxdisable}
EnablesordisablestheLLDPreceiving
functiononaspecicport.
zte(cfg)#lldpport<portlist>med-tlv-select<tlvtype>{enable|disable}
SetstheoptionalMEDTLVtypesent
onaport.
zte(cfg)#lldp{port<portlist>|trunk<trunklist>}max-neighbor<1-8>
Setsthemaximumnumberofneighbors
thatcanbediscoveredonaspecic
LLDPport.
zte(cfg)#clearlldpneighbor[{port<portlist>|trunk<trunklist>}]
ClearsLLDPneighborswithwho
neighborrelationshipshavebeen
established.
zte(cfg)#clearlldpstatistic[{port<portlist>|trunk<trunklist>}]
ClearsstatisticsinformationofLLDP
neighbors.
showlldpconfig[{port<portlist>|trunk<trunklist>}](allconguration
modes)
DisplaysLLDPconguration
information.
showlldpneighbor[{port<portlist>|trunk<trunklist>}](allconguration
modes)
DisplayssummaryinformationofLLDP
neighbors.
showlldpentry[{port<portlist>|trunk<trunklist>}](allconguration
modes)
DisplaysdetailedinformationofLLDP
neighbors.
showlldpstatistic[{port<portlist>|trunk<trunklist>}](allconguration
modes)
DisplaysstatisticsinformationofLLDP
neighbors.
LLDPCongurationInstance
lCongurationDescription
AsshowninFigure4-50,twoswitchesareconnectedtoeachotherthrougha
twisted-pair.Bydefault,theLLDPfunctionisenabled,andallparametersusethe
defaultvalues.Usetheshowcommandtoviewneighborestablishmentinformation.
Figure4-50LLDPCongurationInstance
lCongurationVerication
zte(cfg)#showlldpneighbor
CapabilityCodes:
P-Repeater,B-Bridge,W-WLANAccessPoint,R-Router,T-Telephone
C-DOCSISCableDevice,s-Station,S-Switch,O-Other
InterfaceDeviceIDHoldtimeCapabilityPlatformPortIDNetworkPolicy
4-127
SJ-20120409144109-002|2012-07-02(R1.0)ZTEProprietaryandCondential

Zte ZXR10 2918E Specifications

General

VLANs	4K
Jumbo Frame	9K
Power Supply	AC: 100~240V, 50~60Hz
Operating Temperature	0°C~45°C
Storage Temperature	-40°C~70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5%~95% (non-condensing)
Power Consumption	<=25W