Chapter 4 WEB Configuration
4-5
4.2.2.1 Bridge (Pure Bridge) Connection
Upon configuration of the ATM-related parameters, select the button in front of Bridge
Config to configure the related parameters of a Bridge (pure bridge) connection.
NAS Interface No. Bridge connection interface No.. The configured No. follows
the character string “nas” when an interface is created, for example nas0, nas1.
Encapsulation Type Value range: LLC/VCC.
Upon configuration of the above parameters, click the <Apply>buttontocreatea
2684Bridged encapsulated nas interface. If you need to set up a Bridge (pure bridge)
connection, the nas interface will act as an interface of the bridge connection and form
a bridge group with another LAN side interface (generally eth0). Refer to the Bridge
interface for the operation of adding to the bridge group. If you need to set up a MER
(MAC Encapsulated Routing) connection, you must configure the IP address of this
To Next Page
Loading...
