Chapter 4 WEB Configuration
4-11
4.2.3 Static Route
Click the Routes link in the left of the interface to enter the route configuration
interface of the H100. In the [Route] tab, you can configure and view the static route
information of the H100. The main interface shows the static route list of the H100.
You can configure a new route, modify or delete the existing routes. The [RIP] tab in
the interface is used to configure the dynamic route protocol RIP of the H100.
If you need to add a new route, designate the destination network ID, subnet mask,
next hop IP and click the <Add> button. Once a route is added, the route list will be
refreshed. To add a host-based route, input the destination network ID and the next hop
IP address. In this case, the [Destination Subnet Mask] option is invalid.
If you need to add a network-based route, please check the [Network Based Route]
checkbox to enable the [Destination Subnet Mask] box and input a proper value.
To Next Page
Loading...
