ZXV10 H100 Home Gateway User Manual (Draft)
4-6
nas interface in the interface.
4.2.2.2 PPPoE Connection
If you want to implement the PPPoE dial-up connection through the H100, a PPPoE
connection must be set up. Upon configuration of the ATM-related parameters, select
thebuttoninfrontofPPPoE to configure the related parameters of the PPPoE
connection.
Nas Interface No. Generated 2684 bridge interface No., value range: 0-9.
Encapsulation Type Packet encapsulation type, value range: LLC/VC.
Username&Password PPPoE user name and password to be authenticated.
Authentication type Authentication protocol type, value range: PAP/CHAP.
Idle Time The PPPOE connection should be disconnected after
To Next Page
Loading...
