To access the phone’s Web Configuration Menu
•Connect the computer to the same network as the phone
1
• Make sure the phone is turned on and shows its IP address
• Start a Web browser on your computer
• Enter the phone’s IP address in the address bar of the browser
2
• Enter the administrator’s password to access the Web Configuration
Menu
3
1. The Web-enabled computer has to be connected to the same
sub-network as the phone. This can easily be done by connecting
the computer to the same hub or switch as the phone is
connected to. In absence of a hub/switch (or free ports on the
hub/switch), please connect the computer directly to the phone
using the PC port on the phone.
2. If the phone is properly connected to a working Internet
connection, the phone will display its IP address in Menu->Status.
This address has the format: xxx.xxx.xxx.xxx, where xxx stands
for a number from 0 to 255. You will need this number to access
the Web Configuration Menu. For example, if the phone shows
192.168.0.60, please use “http://192.168.0.60” in the address bar
of your browser.
3. The default administrator password is “admin”; the default end-
user password is “123”.
NOTE:
When changing any settings, always SUBMIT them by pressing
“UPDATE” button on the bottom of the page. Reboot the phone to
have the changes take effect. If, after having submitted some changes,
more settings have to be changed, press the menu option needed.
All the options under Basic Setting and Account Setting, and most of
the options under Advanced Setting do not require reboot after
submitting the changes. Under Advanced Setting, the parameters on
network configuration require reboot after update.
Definitions
This section will describe the options in the Web configuration user interface.
As mentioned, a user can log in as an administrator or end-user.
To Next Page
Loading...