Zte ZXV10 P802L - Page 80

TEL URI
Default is “Disabled”. Users can enable it or select
USER=PHONE.
SIP
Registration
This parameter controls sending REGISTER messages to
the proxy server. The default setting is “Yes”.
Unregister on
Reboot
Default is “No”. If set to “Yes”, the SIP user’s registration
information will be cleared on reboot.
Register
Expiration
This parameter allows user to specify the time frequency
(in minutes) that ZXV10 P802L refreshes its registration
with the specified registrar. The default interval is 60
minutes. The maximum interval is 65,535 minutes (about
45 days).
Reregister
Before
Expiration
This parameter allows user to specify the time frequency
(in seconds) that ZXV10 P802L sends out a re-registration
request before the Register Expiration. By default is 0
second.
Local SIP Port
This parameter defines the local SIP port used to listen
and transmit. The default value is 5060.
SIP
Registration
Failure Retry
Wait Time
Retry registration if the process failed. Default is 20
seconds.
SIP T1 Timeout RFC 3261 SIP T1 timer. Default is 0.5 second.
SIP T2 Interval RFC 3261 SIP T2 timer. Default is 4 seconds.
SIP Transport
Choose SIP Transport between UDP and TCP. Default is
UDP.
SIP URI
Scheme when
using TLS
Select “sip:” or “sips:”. Default is “sips:”.