Zte ZXV10 - Safety Instructions; Special Operational Notes; Critical Safety Guidelines; Device Servicing Information

LED
Color
Status
Description
PO WER
Off
Power off
(Red) Blinking
Software upgrade in progress
(Green) On solid
Power is on
D SL
Off
Non detectable signal
(Green) Blinking
Router attempting to connect
(Green) On solid
Router is on
INTERNET
Off
System in bridge connection status or ADSL is not connected
(Green) Blinking
Partial data transmission through the Router
(Green) On solid
The system has an internet address and ADSL is connected.
IP data packets are transmitted normally.
(Red) On solid
The device attempted an IP connection and failed (no
DHCP response, no PPPoE response, PPPoE quality
check failed, no IP address from IPCP etc.)
LAN1~LAN3
& STB
&
S TB
Off
Ethernet interface is in non communication status
(Green) Blinking
Data received and transmitted through Ethernet
interface.
(Green) On solid
Ethernet is in communication status
WLAN
Off
Wi-Fi interface is off
(Green) Blinking
Data received and transmitted through Wi-Fi
interface
(Green) On solid
Wi-Fi interface is on
LED Indications
There are the following LEDs in the front panel of the ADSL2+ Router . Check the meaning of
each LED below (Image 1).
Image 1
5