ZyXEL G-560 User’s Guide
Management Computer Setup 2-1
Chapter 2
Management Computer Setup
This chapter describes how to prepare your computer to access the G-560 web configurator.
2.1 Introduction
You can connect a computer to the G-560 for management purposes either using an Ethernet connection
(recommended for a first time management session) or wirelessly.
2.2 Wired Connection
You must prepare your computer/computer network to connect to the G-560 if you are using a wired
connection. Your computer’s IP address and subnet mask must be on the same subnet as the G-560. This can
be done by setting up your computer’s IP address.
The following figure shows you an example of accessing your G-560 via a wired connection with an Ethernet
cable.
Figure 2-1 Wired Connection
192.168.1.33
Default IP Address:
192.168.1.2
To Next Page
Loading...
