ZyXEL G-560 User’s Guide
Wireless Screens 6-7
Table 6-1 Wireless Settings
LABEL DESCRIPTION
SSID Wireless stations associating to the access point (AP) must have the same SSID. Enter
a descriptive name (up to 32 printable characters) for the wireless LAN. Spaces are
allowed.
If you are configuring the G-560 from a computer connected to
the wireless LAN and you change the G-560’s SSID, channel or
security settings, you will lose your wireless connection when
you press Apply to confirm. You must then change the wireless
settings of your computer to match the G-560’s new settings.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through passive scanning using a site survey tool.
Channel Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
Refer to the chapter on wizard setup for more information about channels.
Wireless Mode
Select Pure B Mode to allow only IEEE 802.11b compliant WLAN devices to associate
with the G-560.
Select Pure G Mode to allow only IEEE 802.11g compliant WLAN devices to associate
with the G-560.
Select Mixed Mode to allow either IEEE802.11b or IEEE802.11g compliant WLAN
devices to associate with the G-560. The transmission rate of your G-560 might be
reduced.
Select G+ to allow any ZyXEL WLAN devices that support this feature to associate with
the G-560. This permits the G-560 to transmit at a higher speed than the pure G mode.
Select B+ to allow any ZyXEL WLAN devices that support this feature to associate with
the G-560. This permits the G-560 to transmit at a higher speed than the pure B mode.
Advanced Settings
RTS/CTS
Threshold
Enter a value between 0 and 2432. The default is 2432.
You must enter 4096 if you select G+ in the Wireless Mode field.
Fragmentation
Threshold
Enter a value between 256 and 2432. The default is 2432. It is the maximum data
fragment size that can be sent.
You must enter 4096 if you select G+ in the Wireless Mode field.
Enable Intra-
BSS Traffic
Intra-BSS traffic is traffic between wireless stations in the same BSS. Select this check
box to enable Intra-BSS traffic.
To Next Page
Loading...
