Appendix A Product Specifications
ZyXEL G-570S User’s Guide
102
Roaming IEEE 802.11g compliant
IEEE 802.11b compliant
IEEE 802.11f partially compliant (without re-authentication)
Operating Modes Access Point
Client
Bridge
Access Point and Repeater
Wireless Links The ZyXEL Device can act as a bridge, establishing wireless links with other
APs or as a repeater, establishing wireless links to APs.
Up to four bridge links.
Two or more repeater links are supported. It is suggested that you only use
up to three repeater links.
Management Embedded Web Configurator
Command-line interface
Telnet support (Password-protected telnet access to internal configuration
manager).
FTP//Web for firmware downloading and configuration backup and restore.
Limitation of client connections (# is configurable, default: unlimited)
Intra BSS Block (enable/disable)
Output Power Management (4-levels)
Security WPA and IEEE 802.1x security (EAP-TLS, EAP-TTLS, LEAP,. EAP-PEAP
and Win XP PEAP included)
64/128/152-bits WEP
WPA/WPA2 support based on 802.11i standard
Dynamic WEP key exchange
MAC address filtering through WLAN (supports up to 32 MAC address
entries
AES support
Diagnostics Capabilities Built-in Diagnostic Tools for FLASH memory, RAM, Ethernet port and
wireless port.
Syslog
Error log
Trace Log
Packet Log
Hardware Features Restore Factory Defaults (reset) Button
Status LEDs
•PWR
•ETHN
•OTIST
•WLAN
WDS Functionality A Distribution System (DS) is a wired connection between two or more APs,
while a Wireless Distribution System (WDS) is a wireless connection. Your
G-570S supports WDS connections to other G-570S APs. This provides a
cost-effective solution for wireless network expansion.
OTIST (One-Touch
Intelligent Security
Technology)
OTIST allows your ZyXEL Device to assign its SSID and security settings
(WEP or WPA-PSK) to ZyXEL wireless adapters that support OTIST and are
within transmission range. The ZyXEL wireless adapters must also have
OTIST enabled.
Table 31 Feature Specifications (continued)
To Next Page
Loading...
