ZyXEL Communications G-570S - Logs; Figure 50 Management: Logs; Table 27 Management: Logs

Chapter 8 Management Screens
ZyXEL G-570S User’s Guide
90
8.3 Logs
Click Management > Logs to open the Logs screen.
You can view logs and alert messages in this screen. Once the log table is full, old logs are
deleted as new logs are created.
Click a column heading to sort the entries. A triangle indicates the direction of the sort order.
Figure 50 Management: Logs
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the device.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 26 Management: Password (continued)
LABEL DESCRIPTION
Table 27 Management: Logs
LABEL DESCRIPTION
Display Select a category of logs to view.
Refresh Click Refresh to renew the log screen.
Clear Log Click Clear Log to clear all the logs.
# This is the log’s index number.
Time This field displays the time the log was recorded. It is the number of seconds since
the last time the system turned on.
Message This field states the reason for the log.
Source This field lists the source IP address and the port number of the incoming packet
that caused the log.
Destination This field lists the destination IP address and the port number of the outgoing
packet that caused the log.
Note This field displays additional information about the log entry.