ZyXEL Communications G-570S - Notes on OTIST; Figure 45 OTIST in Progress (AP); Figure 46 OTIST in Progress (Client); Figure 47 no AP with OTIST Found

Chapter 7 Wireless Screens
ZyXEL G-570S User’s Guide
84
Figure 45 OTIST in Progress (AP)
Figure 46 OTIST in Progress (Client)
• In the wireless client, you see this screen if it can't find an OTIST-enabled AP (with the
same Setup key). Click OK to go back to the ZyXEL utility main screen.
Figure 47 No AP with OTIST Found
• If there is more than one OTIST-enabled AP within range, you see a screen asking you to
select one AP to get settings from.
7.9.3 Notes on OTIST
1 If you enabled OTIST in the wireless client, you see this screen each time you start the
utility. Click Ye s for it to search for an OTIST-enabled AP.
Figure 48 Start OTIST?
2 If an OTIST-enabled wireless client loses its wireless connection for more than ten
seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually
have the wireless client search for an OTIST-enabled AP, there is no timeout; click
Cancel in the OTIST progress screen to stop the search.)