ZyXEL Communications GS1920-24 - Page 154

Chapter 20 Classifier
GS1920 Series User’s Guide
154
Figure 115 Advanced Application > Classifier
The following table describes the labels in this screen.
Table 63 Advanced Application > Classifier
LABEL DESCRIPTION
Active Select this option to enable this rule.
Name Enter a descriptive name for this rule for identifying purposes.
Layer 2
Specify the fields below to configure a layer 2 classifier.
Ethernet
Type
Select an Ethernet type or select Other and enter the Ethernet type number in hexadecimal
value. Refer to Table 65 on page 156 for information.
Source
MAC
Address
Select Any to apply the rule to all MAC addresses.
To specify a source, select the second choice and type a MAC address in valid MAC address format
(six hexadecimal character pairs).
Port Type the port number to which the rule should be applied. You may choose one port only or all
ports (Any).
Destination
MAC
Address
Select Any to apply the rule to all MAC addresses.
To specify a destination, select the second choice and type a MAC address in valid MAC address
format (six hexadecimal character pairs).
Layer 3
Specify the fields below to configure a layer 3 classifier.