Chapter 35 DHCP
GS1920 Series User’s Guide
286
35.4.3 Configuring DHCPv4 Global Relay
Use this screen to configure global DHCPv4 relay. Click IP Application > DHCP > DHCPv4 in the
navigation panel and click the Global link to display the screen as shown.
Figure 208 IP Application > DHCP > DHCPv4 > Global
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to their last saved values.
Profile Name This field displays the descriptive name of the profile. Click the name to change the
settings.
Circuit-ID
Enable This field displays whether the Circuit ID sub-option is added to client DHCP requests.
Field This field displays the information that is included in the Circuit ID sub-option.
Remote-ID
Enable This field displays whether the Remote ID sub-option is added to client DHCP requests.
Field This field displays the information that is included in the Remote ID sub-option.
Delete Check the entry(ies) that you want to remove in the Delete column and then click the
Delete button.
Cancel Click Cancel to clear the selected check box(es) in the Delete column.
Table 141 IP Application > DHCP > DHCPv4 > Option 82 Profile (continued)
LABEL DESCRIPTION
To Next Page
Loading...
