Chapter 28 PPPoE
GS1920 Series User’s Guide
239
Remote-id Select this option to make the Remote ID settings for a specific VLAN take effect.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 112 Advanced Application > PPPoE > Intermediate Agent > VLAN (continued)
LABEL DESCRIPTION
To Next Page
Loading...
