Chapter 8 Basic Setting
GS1920 Series User’s Guide
70
To view the current amount of power that PDs are receiving from the Switch, click Basic Setting >
PoE Setup.
Figure 52 Basic Setting > PoE Status
The following table describes the labels in this screen.
Table 15 Basic Setting > PoE Status
LABEL DESCRIPTION
PoE Status
PoE Mode This field displays the power management mode used by the Switch, whether it is in
Classification or Consumption mode.
Total Power This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
Consuming
Power (W)
This field displays the amount of power the Switch is currently supplying to the connected
PoE-enabled devices.
Allocated Power
(W)
This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the connected PoE device(s).
Consuming Power (W) can be less than or equal but not more than the Allocated Power
(W).
Remaining
Power (W)
This field displays the amount of power the Switch can still provide for PoE.
Note: The Switch must have at least 16 W of remaining power in order to supply power to a
PoE device, even if the PoE device needs less than 16W.
Port This is the port index number.
State This field shows which ports can receive power from the Switch. You can set this in Section
8.8.1 on page 71.
• Disable - The PD connected to this port cannot get power supply.
• Enable - The PD connected to this port can receive power.
To Next Page
Loading...
