Chapter 35 Cluster Management
GS2200-24/24P User’s Guide
314
35.3 Clustering Management Configuration
Use this screen to configure clustering management. Click Management >
Cluster Management > Configuration to display the next screen.
Figure 175 Management > Cluster Management > Configuration
The following table describes the labels in this screen.
Table 107 Management > Cluster Management > Configuration
LABEL DESCRIPTION
Clustering
Manager
Active Select Active to have this Switch become the cluster manager switch.
A cluster can only have one manager. Other (directly connected)
switches that are set to be cluster managers will not be visible in the
Clustering Candidates list. If a switch that was previously a cluster
member is later set to become a cluster manager, then its Status is
displayed as Error in the Cluster Management Status screen and a
warning icon ( ) appears in the member summary list below.
Name Type a name to identify the Clustering Manager. You may use up to
32 printable characters (spaces are allowed).
To Next Page
Loading...
