IES-1000 Hardware Installation Guide
Hardware Connections 4-7
Figure 4-7 Installation Scenario A
Procedure To Connect To An MDF
Step 1. Connect the RJ-11 connector end of a telephone wire to one of the USER ports on the AAM1008.
Step 2. Connect the other end of the telephone wire to the upper ports of the MDF using a punch-down tool.
Step 3. Connect the telephone wiring from each end-user’s ADSL modem to the lower ports of the MDF.
4.4.3 Installation Scenario B
Phone service is available. There is one MDF from which end-users CO connections are made (see next figure).
To Next Page
Loading...
