ZyXEL Communications IES-1000 - Removing and Installing Network Modules; Removing a G.SHDSL SAM1008 Network Module

IES-1000 Hardware Installation Guide
B Appendix A Removing and Installing a Fuse
Step 3. Using a small flat head screwdriver, gently pry open the right side of the fuse housing (located to the
left of the power cord port receptacle) as shown next.
Diagram 2 Opening the Fuse Housing
Step 4. Gently pull the fuse casing from the IES-1000. The installed fuse is located attached to, and on the
outside of the fuse housing; the spare fuse is located inside the fuse housing.