NBG-418N v2 User’s Guide
115
CHAPTER 12
Static Route
12.1 Overview
This chapter shows you how to configure static routes for your NBG-418N v2.
The NBG-418N v2 usually uses the default gateway to route outbound traffic from computers on
the LAN to the Internet. To have the NBG-418N v2 send data to devices not reachable through the
default gateway, use static routes.
For example, the next figure shows a computer (A) connected to the NBG-418N v2’s LAN interface.
The NBG-418N v2 routes most traffic from A to the Internet through the NBG-418N v2’s default
gateway (R1). You create one static route to connect to services offered by your ISP behind router
R2. You create another static route to communicate with a separate network behind a router R3
connected to the LAN.
Figure 82 Example of Static Routing Topology
12.2 IP Static Route Screen
Click Network > Static Route to open the Static Route screen.
To Next Page
Loading...
