Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
70
Figure 49 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
6.8 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Table 25 Network > Wireless LAN > WPS
LABEL DESCRIPTION
WPS Setup
Enable WPS Click the Enable WPS check box to enable the WPS feature. Click again to disable it.
PIN Number This displays a PIN number last time system generated. Click Generate to generate a
new PIN number.
WPS Status
Status This displays Configured when the NBG-418N v2 has connected to a wireless network
using WPS or when Enable WPS is selected and wireless or wireless security settings
have been changed. The current wireless and wireless security settings also appear in the
screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless
security changes on the NBG-418N v2 or you click Release_Configuration to remove
the configured wireless and wireless security settings.
Release
Configuration
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the NBG-418N v2.
Apply Click Apply to save your changes back to the NBG-418N v2.
Refresh Click Refresh to get this screen information afresh.
To Next Page
Loading...
