Chapter 4 Modes
NBG-418N v2 User’s Guide
36
4.3 Setting your NBG-418N v2 to AP Mode
1 Connect your computer to the LAN port of the NBG-418N v2.
2 The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode and 192.168.1.2 by
default in non-router mode.
3 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and
type the IP address of the NBG-418N v2 as the web address in your web browser.
4 Log into the Web Configurator. See the Chapter 2 on page 16 for instructions on how to do this.
5 Go to Maintenance > Sys OP Mode > General and select Access Point.
6 A pop-up window appears providing information on this mode. Click OK in the pop-up message
window. Click Apply. Your NBG-418N v2 is now in AP Mode.
Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.
4.3.1 Status Screen (AP Mode)
Click on Status. The screen below shows the status screen in AP Mode.
To Next Page
Loading...
