Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
73
The following table describes the labels in this screen.
6.11 AP Select Screen
Use this screen to choose an access point that you want the NBG-418N v2 in universal repeater
mode) to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN > AP Select tab.
Table 28 Network > Wireless LAN > MBSSID
LABEL DESCRIPTION
Network Profiles
Select Click the Select radio button to select the Multiple Basic Service Set Identifier (MBSSID)
you wish to edit.
Scheme This field displays the index number of the SSID.
SSID This field displays the SSID name of the Wireless client.
Security This field displays the Security mode of the wireless client. If there’s no security, it will
display None.
Status This field displays whether the Enable Guest Network check box of the SSID is enabled.
SSID Broadcast This field displays whether the Enable SSID Broadcast check box of the SSID is
enabled.
Wireless Settings--Profile 1
Enable Guest
Network
Click the Enable Guest Network check box to enable this SSID.
Enable SSID
Broadcast
Click the Enable SSID Broadcast check box to activate the SSID broadcast to different
wireless clients.
Allow Guest to
access My Local
Network
Click the Allow Guest to access my Local Network check box to allow the client to
access the local network resources behind the NBG-418N v2.
Enable Wireless
Isolation
Click the Enable Wireless Isolation check box to keep the wireless clients in this SSID
from communicating with each other through the NBG-418N v2.
Name (SSID) This field displays the SSID name you selected using the select radio button.
Security Options--Profile1
Security Mode Select WEP or WPA-PSK(TKIP), WPA2-PSK(AES) or WPA-PSK/WPA2-PSK AES to
add security on this wireless network. The wireless clients which want to associate to this
network must have same wireless security settings as the Device. When you select to use
a security, additional options appears in this screen.
Or you can select None to allow any client to associate this network without any data
encryption or authentication.
See Section 6.4 on page 63 for more details about this field.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
