ZyXEL Communications NBG-418N - Page 45

Chapter 4 Modes
NBG-418N v2 User’s Guide
45
The following table describes the sub-menus.
Table 17 Menu: Client Bridge Mode
LINK TAB FUNCTION
Status This screen shows the NBG-418N v2’s general device, system and
interface status information. Use this screen to access the wizard, and
summary statistics tables.
Network
AP Select AP Select Use this screen to choose an access point that you want the NBG-418N v2
to connect to. You should know the security settings of the target AP.
WLAN
Information
Use this screen to view the SSID and security mode of the AP to which
the NBG-418N v2 is connecting.
Advanced This screen allows you to configure advanced wireless settings.
LAN IP Use this screen to configure LAN IP address and subnet mask.
Maintenance
System General Use this screen to view and change administrative settings such as
system and domain names, password and inactivity timer.
Time Setting Use this screen to change your NBG-418N v2’s time and date.
Logs View Log Use this screen to view the logs for the categories that you selected.
Tools Firmware Use this screen to upload firmware to your NBG-418N v2.
Configuration Use this screen to backup and restore the configuration or reset the
factory defaults to your NBG-418N v2.
Restart This screen allows you to reboot the NBG-418N v2 without turning the
power off.
Sys OP Mode General This screen allows you to select the device operating mode: Router,
Access Point, Universal Repeater or Client Bridge.
Language Language This screen allows you to select the language you prefer.